zackCAのブログ一覧

I installed the headlight duct yesterday and so far there have been no leaks or signs of condensation - hopefully it is sealed up and won't have any problems. We might be going racing this coming weekend, so hopefully the new duct will provide the engine with cool air.

I still have some work planned to finish this up, but here's a little teaser. I removed the fog light on the drivers side, and had an air duct made to fit in the empty slot. The air duct gets routed towards the open end of my ARC air box.

I plan on painting the inside of the headlights black, and tapering the outer edge of the duct a little more.

I received my new connecting rods... they are Eagle Forged rods and are rated to last above 600hp! They also came with ARP rod bolts, which are very strong! This will be an NA build, so I do not need the parts to be strong because of the power output - but because I will rev the engine a lot higher (close to 9000rpm, or whenever it stops making power). The Cosworth heads I plan on buying are built to rev to over 10,000rpm safely!!!

We are building a high compression NA engine for the G35. We purchased a used vq35de motor that we are going to have machined, and we'll build that up.

My pistons got here today... they're Wiseco forged 96mm 11:1 compression ratio. Unfortunately the rods were damaged during shipping, so they shipped another set out due to arrive Friday. Yesterday I got my gasket kit and revup oil pump. On the way I have Eagle rods, ARP main/head studs, upper oil pan, water pump, timing chain set, and front and back timing cover. I'll be ordering Cosworth heads, some very aggressive cams, race bearings, and a bunch of other misc stuff I'm sure.

I have been preparing the G35 for more serious racing, and have removed all of the interior parts that are allowed in my racing class. I also removed all of the sound deadening and seam sealant, and this past weekend we began to stitch weld the inner panels to increase the chassis strength. We will also weld the trunk and front engine bay, including the shock towers. Once we complete the stitch welding we will install the roll cage.

We are preparing the car for next months race at Laguna Seca raceway!

Here I am preparing the welder-


Progress on the passenger side floor panels-


My friend Dave showing me how to use the welder-