はぐ@ap1のブログ一覧

Clear the DTC Memory('00-05Models)
Special Tools Required
SCS Service Connector 07PAZ-001010A
To erase the DTC(s) from the SRS unit,use the HDS or　follow this procedure.

1.Make sure the ignition switch is OFF.
2.Connect the SCS service connector(A) to the yellow MES 2P connector(B). Do not use a jumper wire.
3.Turn the ignition switch ON(II).
4.The SRS indicator will come on for about 6 seconds,and then go off. Remove the SCS service connector from the MES 2P connector with in 4 seconds after the indicator goes off.
5.The SRS indicator will come on again. Reconnect the SCS service connector to the MES 2P connector within 4 seconds after the indicator comes on.
6.When the SRS indicator goes off, remove the SCS service connector from the MES 2P connector within 4 seconds.
7.The SRS indicator will blink two times indicating that the memory has been cleared.
8.Turn the ignition switch OFF.
9.Turn the ignition switch ON(II) again. If the SRS indicator comes on for 6 seconds and then goes off, the SRS is OK.