
取り付け方法の返事が来ました。
要はグリスを塗って、車の重みで押し込めですか。
The bush needs to be fitted to the car to make sense.
To install them is as follows.
1 - Fit the rubber bush to the car - Lift rubber bush up in to suspension strut top and roll the top lip of the rubber bush over the metal of the car.
2 - Grease the lower part of the top mount (widest piece) an insert it from underneath.
3 - Put the shock up from underneath - using the supplied spacers to make sure the damper rod/spring topcup doesn't foul the lower section of the topmount.
4 - Put the hub on and place a jack underneath the outer ARB of the tca and raise the jack to lift the lower cup into the bush (this takes a little bit of effort here)
5 - Making sure the thread of the lower cup has still got grease covering on it screw the top plate and big washer plate on the lower section of the mount.
6 - Arrange top spacers to make sure no contact of the nut to body.
Finished
Posted at 2009/02/20 00:11:43 | |
トラックバック(0) |
密輸 | 日記