いりあんのブログ一覧

レベル3
関東地方にまた出張していただきました。
麺はいりあんお好みの太麺で良かったんですが、食べて行くと塩からさが目立ってきました。
トッピングに煮卵つけたんですが、これも私のような年齢では塩からく、大変でした
横浜市西区南幸2-12-6 ストークミキ １Ｆ

Ross-TechのDanaさんから速攻で返事が来ました
WorkShop Code/Importer Number/Equipment Number がゼロの時、変更を受け付けないモジュールがあるので、このため入力を求めているようです。
詳しくは下記をご覧ください

Some control modules will refuse any modifications (coding or adaptation) if those values are zero. When a factory scan tool is used the real dealer assigned 5 digit WSC, 3 digit importer code from the country the dealer is from and the 5 digit equipment serial numbers are always written to the module. VCDS gives users the opportunity to enter their assigned values in VCDS which is very handy for VW/Audi dealer technicians:

http://www.ross-tech.com/vcds/tour/908/options-2.png

http://www.ross-tech.com/vcds/tour/option_screen.html#reduce


Due to so many reports of coding and adaptation values being rejected lately the last Beta series included the default pop-up box where the user has to select [Yes] followed by [Do It!] to write the values:

http://www.ross-tech.com/vcds/tour/option_screen.html#reduce

This was the most common issue which prompted a UDS SRI specific page:

http://wiki.ross-tech.com/wiki/index.php/VW_Golf/Golf_Plus_%285K/52%29_Instrument_Cluster#Service_Reminder

It should have written those values after you clicked Yes and Do It, but I cannot duplicate the problem because all of the modules in my vehicle have proper values stored already. If we receive any other reports of similar behavior this will be something worth looking into on our side.