• 車種別
  • パーツ
  • 整備手帳
  • ブログ
  • みんカラ+

Kinebohのブログ一覧

2012年11月18日 イイね!

VW 1302 Drag link

VW 1302 Drag linkDrag link assembly was removed from VW 1302 Super Beetle for the maintenance after 2 years use, because some lack of lubricant caused backlash a bit between drag link main shaft and case. Harder with much viscosity grease was applied there and reassembled installing on original body position. The steering stability has increased with such trifle maintenance at all. Ester base film simms, 0,2mm thickness, were placed on upper and surface of the case for the purpose both to seal the grease inside and to eliminate the influence of the lateral stroke of the main shaft in the case.
Posted at 2012/11/18 17:01:03 | トラックバック(0) | 日記
2012年11月18日 イイね!

Lens cleaning

Lens cleaningEBC Fujinon 28/3,5 was disassembled in parts to remove sticky old lubricant in iris control ring and iris module inside, also undesirable mold should be removed in the lens inside at the same time. As usual, metal lens case make it possible to perform periodical maintenance as to original condition. Uninvited guest to the lens mechanism often appears in the most inconvenient portions unfavorably. Lens overhauling procedure remind me of special techniques and memories that I had forgotten.
Methyl alcohol-Ether mixture solution would be used for lens surface cleaning, the ration is 3:7 though factory engineer recommends 4:6, the reason is the humidity in the room air, the solution is called as Ether. The centricity of the lenses should be confirmed when being assembled in position, because the center displacement of the element does harm on the performance of the lens. It is often the case that the lens case accuracy is not enough as to affect the assembly tolerance, thin layer of adjusting sim is put around the round surface to compensate the unnecessary space to establish the centricity of the lens piece. As the lens pieces themselves are finished well promptly, this kind of tiresome adjusting when re-assembled is effective to obtain the designed original performance. Lens outer round surface and the supporting case should be fit well like piston and cylinder of the motor of mobiles. The lens for large format is engineered so especially those made in former West Germany.
Posted at 2012/11/18 05:13:07 | トラックバック(0) | 日記

プロフィール

「Difficulty in the establishment of wheel alignment http://cvw.jp/b/139985/46096876/
何シテル?   05/10 07:44
Kineboh! It's me!
みんカラ新規会員登録

ユーザー内検索

愛車一覧

フォルクスワーゲン ビートル フォルクスワーゲン ビートル
Original Marina Blue paint with rusting a bi ...
フォルクスワーゲン ゴルフ (ハッチバック) フォルクスワーゲン ゴルフ (ハッチバック)
Unexpectedly, I was obliged to change vehicl ...
アウディ A3 アウディ A3
34,000km used for 9 years second handed vehi ...
トヨタ カルディナ Cal (トヨタ カルディナ)
Though some anxiety existed before I obtain ...
ヘルプ利用規約サイトマップ
© LY Corporation